VESPA GT 200, Руководство по ремонту

Страница: 159 / 287

159
-
Place the cover onto the engine crankcase and, by tightening the three screws (with
copper washers) with the prescribed torque, fix the cover to its seat.
Tightening torques:
Chain cover fixing screw 2.6-3.3 lbs·ft
( 3.5-4.5 N·m )
10.10.8 Fitting the By-Pass and the Oil Sump
- Fit the by-pass piston in its seat.
-
Insert the adjusting spring.
-
Fit a new sump gasket.
- Fit the two dowel bolts.
- Install the sump taking care to insert the spring
into the projection in the sump.
-
Fit the screws and the rear brake pipe clamps by
following the removing procedure in the reverse
order.
- Tighten the screws with the prescribed torque.
Tightening torques:
Oil sump screws 7.4-10.3 lbs·ft
( 10-14 N·m )
-
Fit the driving pulley assembly, the belt, the
pinion and the transmission cover as described
in the chapter “Transmission”.
-
Regarding the checks relating to the lubrication
of the connecting rod assembly, refer to the
chapter “Crankcase and Crankshaft”.
10.10.9 Removing the Intake Manifold
- Remove the flywheel cover assembly.
-
Loosen the three screws and remove the intake
manifold.