VESPA GT 200, Руководство по ремонту

Страница: 145 / 287

145
10.8.5 Checking the Low Oil Pressure Switch
- Using a multimeter, check for continuity between
connector 4 and ground (with engine off).
10.8.6 Checking the Pick-Up
- Check that the resistance between connection 2
and ground is approximately 105-124 O at 68
° F
(20 ° C).
- If the measured resistance is not as specified,
replace the faulty parts.
Note: Resistance values are rated for
measurements taken at, or near, the indicated
temperature. Checks carried out with the stator at
operating temperature give higher resistances than
the rated values.
10.8.7 Checking the Flywheel
- Check the integrity of the internal plastic parts of the flywheel and the Pick-Up control
plate.
10.8.8 Fitting the Stator Assembly
-
Fit the stator and the flywheel by following the
removing procedure in the reverse order.
Tighten the fastenings with the prescribed
torque.
-
Position the wiring as shown in the figure.
Tightening torques:
Stator and pick-up screws 2.2-2.9 lbs·ft
( 3-4 N·m )
Note: The pick-up wire must be placed between
the upper screw and the dowel bolt, as shown here.