VESPA GT 200, Руководство по ремонту

Страница: 102 / 287

102
9.2.9 Checking the Voltage Regulator
With a fully charged battery and all lights off,
measure the voltage at the battery terminals (see
figure) with the engine running at high speed.
Standard voltage:
Voltage regulator <15.2V
If a higher voltage is detected, replace the regulator.
If the voltage is less than 14 V, check the stator and
its wiring.
9.2.10 Stator check
Disconnect the voltage regulator connector and check
for continuity between each one of the three yellow
wires and the other two.
Standard resistance:
Stator 0.7-0.9O
Also check that each yellow wire is insulated from
earth.
If any of the measured values are not as specified,
repeat the check directly on the stator. If incorrect
values are still found, replace the stator, otherwise
repair the wiring.