80
8.1.6
Starting Problems
Symptom
Possible Cause
Operation
Flat battery
Check the battery charge level. If the
battery shows any sign of sulphation,
replace it with a new one
Carburetor dirty or fuel pump
faulty
Remove, wash with solvent and dry
with compressed air, or replace
Spark plug faulty or spark
advance incorrect
Replace the spark plug or check the
ignition circuit components
Air filter clogged or dirty
Remove the sponge, wash it in water
and shampoo, and then soak it in a
50% mixture of fuel and oil
(recommended: Selenia Air Filter
Oil). Squeeze the sponge without
twisting, allow it to drip and then
replace it
Automatic choke failure
Check the mechanical sliding and the
electrical connection and ensure that
power
is
supplied.
Replace
if
necessary
Engine flooded
Open the throttle wide and try to
start the engine. If the engine does
not start, remove the spark plug, dry
it and, before replacing it, crank the
engine to expel the excess of fuel,
keeping the cap connected to the
spark plug and the latter to earth. If
the fuel has run out, refuel and then
start the engine
Incorrect valve seal or wrong
valve adjustment
Inspect the head and/or set the
correct clearance
Starting speed too low or
starting system and motor
faulty
Check starter motor, starting system
and torque limiter
Starting
problems
Altered fuel characteristics
Drain worn fuel and refuel
Содержание GT 200
Страница 1: ......
Страница 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Страница 151: ...151 10 10 Lubrication Circuit ...
Страница 195: ...195 Remove the main jet Loosen the emulsion jet Tilt the carburetor and remove the emulsion jet ...