![background image](http://html1.mh-extra.com/html/ves/elite-rs-h-series/elite-rs-h-series_installation-manual_1008675069.webp)
Maintenance and Repair 5
VES, LLC
Elite-RS Panel Installation Manual
VF3529-00, Revision E01.03
H-Series
59 of 146
3 Amp Power-Supply Fuse
The 3 Amp fuse located on the circuit board of the power supply. Remove this fuse and install a replacement by
following the procedures described below.
Removing the Fuse
To remove the fuse:
The figure below illustrates the location of the 3 Amp fuse on the power supply of the Main Board.
Figure 5-2
3 Amp Fuse Location
Installing the Replacement Fuse
To install the replacement fuse:
1
Turn off AC power to the control panel at the source.
2
Remove the AC Power terminal-connector from the connection at the lower-front of the control panel.
3
Locate the housing containing the 3 Amp fuse.
4
Remove the upper-half of the fuse-housing with long-nose-pliers.
5
Remove the fuse from the upper-half of the fuse-housing.
1
Insert the fuse in the upper-housing.
2
Center the position of the fuse in the upper-housing.
3
Press the upper-housing on the lower-housing until the halves snap together.
4
Restore AC power to the power supply.
5
Verify that the Elite-RS Panel completes the booting process to confirm that the Power Supply is operating
correctly.
WARNING!
This is a high voltage circuit area. An electrical shock hazard exists in this area when the control panel is
operating. Do not remove the fuse while the control panel is powered. Disconnect AC power at the source
before attempting to remove the 3 Amp fuse.
WARNING
HIGH
VOLTAGE
D1090 ISSUE 01
FUSE
5X20
FUS E
5X 20