![background image](http://html1.mh-extra.com/html/ves/elite-rs-h-series/elite-rs-h-series_installation-manual_1008675121.webp)
Communications Format F
VES, LLC
Elite-RS Panel Installation Manual VF3529-00, Revision E01.03
H-Series
111 of 146
Dialing
Choose an option that would be used universally for both telephone lines; Tone, Pulse or Both. When ‘both’ is
selected, the embedded dialer will attempt to dial touchtone and then attempt to dial using pulse if not successful.
Use Lines
Check the boxes for the phone lines which are active 1, 2 or both 1 & 2.
Voltage checks will only be conducted on those lines which are checked. Failure to check either line will result in
no calls being made.
Number of rings before Answer
The capability for an incoming remote access call is available through the embedded dialer. Remote calls can only be
answered on line #1. If no additional telephones are connected, the suggested value should be 2. If additional tele-
phones are connected
Enter a value which will not cause conflict with other equipment on the telephone line.
The
Accounts Tab
allows entry of information instructing the dialer how to send data to the monitoring center.
Test Code Time
The embedded dialer will send a 24 hour test report signal based upon the test code time filled in within the Accounts
tab of the configure dialer settings dialog. If the 4
th
reporting criteria (Report Service/Test) box is not enabled, no test
signal will be generated.
Report By Zone or by Point
By Default signals are sent to the monitoring center by Zone. Checking this box will allow point reporting to occur.
Protocol
Choose the appropriate Protocol that you wish to transmit (SIA or Contact ID)
Account Number
Your monitoring center account number (4 digits in length). If contact ID this number should always be in Decimal, If
SIA this number may be hexadecimal.
Reporting Criteria
By checking these boxes it is possible to alter the amount of information sent to the monitoring center. In a typical
installation it would be recommended that boxes 1-4 be checked off.
Reference Figure F-5 for a typical installation example.
If the user would like to generate signals when the alarm silence or reset button have been activated, also check box
5 (typically you would not want to engage option 5, because of the additional traffic / calls which would be sent).
Within the account 2 & 4 tabs there is a sixth check box, Backup Report. This box should be checked if Account 2 is
a backup telephone number for Account 1 or Account 4 is a backup telephone number for Account 3. The ‘Backup
Report’ philosophy indicates that this number will only be tried if their compliments (1 & 3) do not reach the receiver.