Communications Format F
VES, LLC
Elite-RS Panel Installation Manual
VF3529-00, Revision E01.03
H-Series
110 of 146
Phone Numbers
The embedded dialer allows a large array of reporting options based upon the setup options selected. Each of the
phone number uses is explained below. In the most typical applications only phone number 1, or 1 & 2 are used. Each
of the lines should be terminated by a RJ31X jack at the Control panel. Each of the lines should also be wired for loop
start operation.
Figure F-5 illustrates dialer configuration settings for the Account 2 tab:
Figure F-5
Account 2 tab
Site Number
This is an optional field. If populated, this would be the telephone number of
Line #1 connected to the RS Panel. This number would be dialed by Loop
Explorer if a remote communication session from your PC was desired.
Phone Number 1
This is the phone number of your monitoring center. Dialing modifiers may be
used in the string (for example, = pause), although any modifiers must be valid
for both telephone lines.
Phone Number 2
Can be used for two purposes. The backup telephone number of your monitoring
center (select backup reporting) and Redundant signal reporting.
Reference Figure F-5 for the backup reporting selection.
Phone Number 3
This is the phone number used when redundant reporting is desired and
Phone Number 2 is used for backup purposes.
Phone Number 4
Can be used for two purposes. The backup telephone number of your monitoring
center (select backup reporting) and Redundant signal reporting.
Reference Figure F-5 for the backup reporting selection.
