Marquee ACON Ultra Installation/Operation Guide
1-3
On the backside of each camera are several DIP switches
and controls. If these settings are not properly set, the
camera will not properly operate. Verify the following
factory settings; See Figure 1-1.
1. On the 10-postion DIP switch, verify that switches 8
(FR/FL) and 9 (
γ
) are in the “on” position and all
other switches are off. Both the “High 75
Ω
” and “IN
OUT” DIP switches are set to HD
2. Ensure the M GAIN control is fully clockwise (CW).
In some situations, where the screen glare is very
high, the M GAIN may not be set fully CW.
1
2
3
4
5
6
7
8
9
0
Figure 1-1. Camera Factory Settings
Camera Address Switch Location and Setting.
Each camera unit has an individual address or ID. This ID is used to communicate with the cameras’ used in a
network application or individually with the corresponding projector ID. Although when a camera unit is mounted
on a projector, the projector address (ID) does not have to match that of the camera ID.
However, it is highly
recommended that they do
. Refer to your relevant projector User’s Guide for selecting and setting the projectors’
address (ID).
NOTE:
See Section 1.4.5 for logging in the relevant projector and
AU
system information.
1.3.1.1
Setting the Camera Address (ID)
1. Remove the camera assembly and hardware from the package.
2. Visually inspect the contents and each component carefully for any damage.
3. Access to the Motion Control Board 5-position DIP switch (S1) can be accomplished through either the
top or front vent holes.
4. Locate S1 (Figure 1-2, on the ACON Ultra 2 split unit, S1 is located on the electronics chassis) and
using a long flat head screwdriver to carefully set the switches to the desired positions.
NOTE:
S1 positions 1(LSB) through 4 (MSB) are used to set the camera’s ID and switch 5 is used to set
either software or hardware address. Switch 5 is normally set to off.
Switch 1 (S1)
Position
4
3
2
1
0*
OFF OFF OFF OFF
1
OFF OFF OFF
On
2
OFF OFF
On
OFF
3
OFF OFF
On
On
4
OFF
On
OFF OFF
5
OFF
On
OFF
On
6
OFF
On
On
OFF
7
OFF
On
On
On
8
On
OFF OFF OFF
9
On
OFF OFF
On
10
On
OFF
On
OFF
C
a
m
e
ra
I
D
(
A
d
d
re
s
s
)
11
On
OFF
On
On
*Not recommended to use address
“0” unless required
S1
Содержание 69871-01
