u-blox ZED-F9P Interface Description - Manual
Advance Information
change its current configuration immediately after receiving a configuration message. The receiver will always
use the current configuration only.
The current configuration is loaded from permanent configuration hard-coded in the receiver firmware (the
defaults) and from non-volatile memory (user configuration) on startup of the receiver. Changes made to the
current configuration at run-time will be lost when there is a power cycle, a hardware reset or a (complete)
controlled software reset (see chapter Forcing a Receiver Reset in the
).
See the
section for a detailed description of the receiver configuration system, the
explanation of the configuration concept and its principles and interfaces.
The configuration interface has changed from earlier u-blox positioning receivers. There is some
backwards compatibility. Users are strongly advised to only use the
to in the following sections. See also
Legacy Configuration Interface Compatibility
.
for a basic receiver configuration most commonly used.
UBX-18010854 - R04
Advance Information
Page 4 of 259
