Turner OCTO
®
Assembly Guide
©Turner Access Ltd 65 Craigton Road, Glasgow, G51 3EQ, Scotland
Section 1 Page 16
TA3/01/50/01_Iss1Rev3
Rev.No.Jan17/Rev3
5. Fit Horizontal (ledger) between the inner
Standards (along length of bay) in bottom cups.
6. C
heck levels along 1st transom, ledger and finally
2nd transom and check that bay is square.
Note
It may be advantageous to place a Deck in the bay to assist in “squaring” the bay. Place
an appropriate-sized Deck in the bay against the inside Horizontal (it should be parallel).
If required, make any adjustments and repeat as necessary.
7. Fix required Bracing Guardrail to outer Standard
and leave to “hang” in direction of length of
scaffold.
8. Place next Standard on Jack (set to minimum
height), lift into position and connect Guardrail.
Adjust Jack to sit under Standard.
Note
On sloping ground, steps should
be cut to ensure the base boards lie flat
and level.
SECTION 1.4 Safety Information