TSE Calorimetry PhenoMaster, Инструкция по эксплуатации оборудования

Страница: 59 / 70

CaloSys Modules 59
•
Ensure that humidity is <90%.
NOTICE
- Instrument damage!
The mass flow controllers in the Control Units are sensitive instruments that must be
protected against dust particles.
Check the air filters of the air supply pumps every month and replace them when dirty but LATEST
every three months (see Section 10.2.1). Failure to do so will void the warranty.
11.7. Vacuum Pump
System configuration
This section describes vacuum pumps of CaloSys modules working with pull principle (see Section
11.1.2). For instructions of air supply pumps of CaloSys modules working with push principle (see
Section 11.1.1), see Section 11.7.
NOTICE
- Reduced lifetime!
If Calorimetry Process Control Units and Air Pumps are powered ON without operating the
system, this may reduce lifetime of devices.
•
Always run system software when devices are powered ON.
•
Power OFF devices after use.
Vacuum pumps allow to generate and maintain the set airflow within the CaloSys module.
•
The pump is suitable exclusively for air and NOT for pumping liquids or gases. Max.
permissible humidity <90%.
•
Under no circumstances you should grease or oil the pump!
•
The ambient temperature must not fall below -5°C (23°F) and must not 40°C (104°F).
You are NOT allowed to operate the pump close to explosive liquids or on potentially
explosive premises.
•
Choking the air flow by reducing the outlet or closing it leads to premature wear of the pump. If
the air flow fails, the windings overheat and burn.
•
Unusual noises may indicate that a diaphragm has broken. In this case, unplug device from
mains supply and contact TSE Service .
Fig. 32 Vacuum pump
info@TSE-Systems.com www.TSE-Systems.com