Trumpf TruConvert DC 1000 Series, Руководство оператора

Страница: 98 / 112

− 0: No configuration
This configuration only occurs in the event of an error,
e.g., if there is no connection to the modules (check
cables) or if an incorrect module type was detected
(check alarm messages).
− 1: Simulator
The system control alone is used and connected mod-
ules are simulated.
− 2: DC-DC only
Only DC-DC modules are connected to the system
control.
− 3: n (AC-DC + m DC-DC)
AC/DC and DC/DC modules are connected to the sys-
tem control.
3. To save the selection: press "Save selection".
4. To restart the TruConvert System Control: press "Restart
CPU".
1 Display of the current device
status
2 Main operating parameters
(start page)
3 Device configuration (time and
network settings)
4 Software update
5 Device identification (display
only)
6 Submenu
7 Sidebar (alarm, warning and
event messages)
Start screen Fig. 7-14
The system is ready for operation: It is in "Idle" mode and
the start screen is displayed.
7 ‐ 30
System configuration 2020-07-01 A67-0140-00.BKen-0
01-05