Trumpf TruConvert DC 1000 Series, Руководство оператора

Страница: 76 / 112

The number of available DC-DC modules is displayed in
"Available slave modules".
or
Ø To uniformly set the set values for all DC-DC modules:
set the "Slave number" = 0.
23. Set the following in the "Device control DC-DC" area:
− "Set value battery current [A]": battery current set value
in A.
Charge battery: enter negative value (-250 to 0).
Discharge battery: enter positive value (0 to +250).
− "Battery current slope [A/ms]": maximum allowed battery
current change in A/ms (default value = 100 A/ms).
24. To start the transmission of power:
− For "Activate power stage [bit]", enter = "1".
− Press key
↲
.
The status changes from "Idle" to "Operation".
The status LEDs on the AC-DC module and system control
light up orange. The contactor connects the mains.
25. To stop the transmission of power:
− For "Activate power stage [bit]", enter = "0".
− Press key
↲
.
The status changes from "Operation" to "Idle".
The status LEDs on the AC-DC module and system control
light up green. The contactor disconnects the mains.
The initial commissioning is completed.
The device can now continue to be operated via the web-based
user interface or via Modbus.
Tip
The Modbus register provides an overview of the set default val-
ues
(see "Modbus Register Map", pg. 7 ‐ 11) .
7 ‐ 8
Commissioning 2020-07-01 A67-0140-00.BKen-0
01-05
Stop transmission of power