Trumpf TruConvert DC 1000 Series, Руководство оператора

Страница: 92 / 112

7. Actual values
7.1 Display actual values
Note
Some actual values can only be displayed if a specific DC-
DC module was selected. To display the actual values for
battery voltage, DC link voltage and temperature, the num-
ber of the slave to be addressed must be specified.
If the number of the slave to be addressed is set = 0 (over-
view of the entire system),
0
is displayed for these actual
values.
1. Either
Ø To display the actual values for one DC-DC module:
enter the number of the slave that is to be addressed.
or
Ø To display the actual values for the entire system: set
the number of the slave that is to be addressed = 0.
2. Displaying the current battery values.
− User interface:
Select >
Operation > Device Control DC-DC .
Read the actual values in the "Status Battery Interface"
area.
− Modbus:
Read actual values
(see "Tab. 7-7", pg. 7
‐
15) .
3. Display currently intervening regulator.
The following regulators can be active: Pmax, max. charging
current, max. battery voltage and min. battery voltage.
− User interface:
Select >
Operation > Device Control DC-DC Mode .
Read off the active regulator in the "Status Battery Inter-
face" area under "Current Limiting Status".
− Modbus:
Read status of current limiting
(see "Tab. 7-7", pg. 7 ‐ 15) .
4. Display current DC link voltage.
− User interface:
Select >
Operation > Device Control DC-DC .
Read the actual value in the "Status DC Link" area.
− Modbus:
Read actual value
(see "Tab. 7-7", pg. 7 ‐ 15) .
5. Display the current temperature.
7 ‐ 24
Actual values 2020-07-01 A67-0140-00.BKen-0
01-05