Trumpf TruConvert DC 1000 Series, Руководство оператора

Страница: 75 / 112

19. Enter current-voltage characteristic curve in the "Voltage Cur-
rent Characteristics (VCC) Settings" area (see "Fig. 3-1",
pg. 3 ‐ 4) :
− "VCC Start Point Current [A]": battery current at mini-
mum battery voltage.
− "VCC End Point Current [A]": battery current upon reach-
ing "VCC End Point Voltage [V]".
− "VCC End Point Voltage [V]": battery voltage.
The charging and discharging current of a battery are set as
a function of the voltage with the "VCC Settings". The val-
ues must be selected so that they lie in the shaded part of
the VCC curve.
The dashed line shows the "VCC Settings" on delivery
(default values).
VCC curve Fig. 7-4
20. Check the device status in the upper left corner of the user
interface:
−
"Device status: Idle": Idle: The device is ready for use.
− "Device status: Error, Power Up": Error: The device is
not ready for use. An alarm message is pending
(see
"Displaying and resetting messages", pg. 7
‐
18) .
or
Ø Check status LED 1 on the DC-DC module:
− LED flashes green: The device is ready for use.
− LED flashes red: The device is not ready for use. An
alarm message is pending
(see "Displaying and resetting
messages", pg. 7 ‐ 18) .
21. Select > Operation > Device control DC-DC .
22. Either
Ø To set the set values for a single DC-DC module: Enter
the number of the slave in the "Device control DC-DC"
area under "Slave module selection".
A67-0140-00.BKen-0
01-05 2020-07-01 Commissioning
7 ‐ 7
Start transmission of power