Trumpf 1717020, Инструкция по эксплуатации

Страница: 79 / 90

Troubleshooting
4990113_030_01 — 2069106 — 2017–11–02
79
17 Troubleshooting
Error Possible cause Correction
No function when pressing a key Operating table not switched on Press the O
N
key on the column
keypad.
Operating table cannot be
switched on
Operating table discharged Operate and charge operating
table with mains power cable
No function on column keypad Key lock is active Release the keyboard or use a
two-key control
(Press the O
N
key and
simultaneously press the desired
function on the column keypad)
No movement when key is
pressed, instead an audible error
signal sounds
Function is either not possible or
not permitted at that time
–
No function when pressing a key,
B
ATTERY STATUS
indicator on the
column keypad flashes
Operating table discharged Operate and charge operating
table with mains power cable
Operating table cannot be
charged, B
ATTERY STATUS
indicator
does not flash
Either the control electronics,
mains power cable or input fuse
(2 x 10 AT) is defective
Contact Technical Customer
Service
Operating table cannot be run on
line power, E
XTERNAL POWER
SUPPLY
indicator does not
illuminate
The mains power supply cable is
defective
Contact Technical Customer
Service
Operating table cannot be
charged, E
XTERNAL POWER SUPPLY
indicator does not illuminate
Mains input on the operating
table is defective
Contact Technical Customer
Service
Operating table cannot be
charged, B
ATTERY STATUS
indicator
on the column keypad flashes
The operating table column or the
battery is defective
Contact Technical Customer
Service
The battery in the power supply
unit cannot be charged,
BATTERY
STATUS
display on the power
supply unit is flashing
Power supply unit or the battery is
defective
Contact Technical Customer
Service
(Reverse) Trendelenburg position
cannot be fully attained
The tilt angle setting is too high Reduce the tilt
Tilt position cannot be fully
attained
The (reverse) Trendelenburg
angle setting is too high
Reduce the (reverse)
Trendelenburg setting
Leg sections cannot be adjusted
far enough down
Longitudinal travel too far toward
the head end
Adjust longitudinal travel toward
the foot end