Trumpf 1717020, Инструкция по эксплуатации

Страница: 45 / 90

Power supply
4990113_030_01 — 2069106 — 2017–11–02
45
5.3 External power supply (available for TruSystem 7500 Hybrid MR)
The operating table column TruSystem 7500 Hybrid MR has an
external power supply. The power supply is outside the operating
theater. No operator action on the external power supply unit is
necessary to operate the operating table.
5.4 Charging the operating table
5.4.1 mobile operating table column
The mobile operating table column should be charged daily after
use to ensure it is always ready for use.
The battery charge status can be seen on the display [a1] on the
column keypad. Observe the display while using the operating
table. The operating table column must be charged if the display
lights up red. In addition, an audible signal sounds that repeats at
intervals of a few minutes.
1. Set the external power supply connection for the operating
table (see page 43).
Indicator [a3] on the column keypad lights up.
Indicator [a1] on the column keypad flashes green within 1
minute after plugging in the mains power cable.
2. Operating table column is charging. Charging starts 1 minute
after the last movement of the operating table.
If the batteries are completely discharged, recharging will take
approximately 3 hours. Indicator [a1] on the column keypad
lights green when the batteries are fully charged.
3. Disconnect the operating table from the external power supply
(see page 43). Indicator [a3] on the column keypad goes out.
4. Turn off the operating table. This keeps the batteries fully
charged until the next use.
5.4.2 Fixed installation operating table column
The batteries for the emergency power supply are automatically
charged, as the operating table is firmly connected to the external
power supply.