Trinnov Audio Altitude16, Руководство пользователя

Страница: 72 / 156

Altitude
16
72
The Quick Setup menu is divided into 3 main sections:
1. Set Filters : This section is to specify the filter type and frequencies that will be applied;
2. Apply to selected speakers : Here, you can choose the speakers on which you can apply the filters selected in the first
section;
3. And apply the associated sub(s) : Select the sub(s) associated with the group of speakers and filters.
The 3 sections are detailed in the sub-chapters below.
The configuration steps are the followings:
• Enter the desired settings in the 1| Set filters table;
• Select the speakers on which you want to apply those settings on the 2| Apply to selected speakers section;
• … and the associated sub(s) in the And apply to associated sub(s) section;
• Press on the Apply button to validate;
• Do the same manipulation for another group of speakers and sub if needed;
• Listen and adjust if required;
• Save the preset.
NOTE: It is not possible to apply the settings if no subs are selected. This means that you cannot disable bass
management on several speakers at the same time with the Quick Setup menu. To do so, please use the Individual
Setup described in the next sub-chapter.
6.4.3.1 _SET FILTERS
As shown below, this first section is divided in 3 different groups of settings:
• Low Pass – Sub(s) : These settings will determine the cutoff frequency below which the signal from the channel will be
redirected and played by the subwoofer(s). You can here select the type of filter (Linkwitz-Riley, Bessel or Butterworth), the
cutoff frequency and the slope used by this filter. These settings are only applied to the signal redirected to the subwoofer(s).
• Extra settings for sub(s) : These additional settings give the possibility to invert the polarity and adjust the gain of the
signal redirected to the subwoofer(s). These settings are only applied to the signal redirected to the subwoofer(s).
• High Pass – Satellites : This section will determine the low-end cutoff frequency of the signal sent to the satellites. You
can here select the type of filter (Linkwitz-Riley, Bessel or Butterworth), the cutoff frequency and the slope used by this
filter. These settings are applied to the signal directed to the Satellites.
6.4.3.2 _APPLY TO SELECTED SPEAKERS
The second section is here to define the group of speakers on which the filters will be applied. The speakers, or satellites,
are only concerned by the High Pass filter. The speaker selection is done by checking the box on the left side of each
speaker’s name.
Two buttons are in the Top right corner of this second section:
• Unselect all: Clicking on this button unselects every speaker;
• Select all: Clicking on this speaker selects every speaker.