Trinnov Audio Altitude16, Руководство пользователя

Страница: 52 / 156

Altitude
16
52
NOTE: An old configuration that was not created with the Wizard cannot be load.
IMPORTANT NOTE: After this step, any click on Previous will automatically setup the main screen to default
configuration.
6.2 _DEFINE YOUR PRESET
This step will allow you to save your calibration in the easiest way possible. Changes will
be automatically applied to the preset that you have selected.
You can create a new preset. The Wizard invites you to enter a name for your new preset.
Figure 44: Select a new preset in the Wizard
If you have already reached the limit of presets number, Save in a new preset would not be available and the color of the option
would turn in grey. You can also chose to override an existing preset. Click on the arrow and select the preset you want to override
!
IMPORTANT NOTE: Attention, after this step, any click on Previous will automatically setup the main screen to
default configuration.
Once your preset is selected, click on Next.
6.3 _SETUP YOUR ROOM
In this chapter, we assume that a specific set of speakers have already been defined and
installed in a room. In order to support multiple surround and 3D formats, we recommend
relying on the expertise of a Certified Trinnov Installer . They can design a speaker
configuration that meets your requirements and can also recommend optimal speaker
placements according to your room’s dimensions and acoustics.
For additional information about the Dolby, DTS and Auro-3D recommendations, please see the Appendix of this document
and the related documents from Dolby, DTS and Auro.
The overall procedure to configure a speaker system is as follows:
• Select an initial speaker layout from one of the available templates;
• If necessary, Add or Remove speakers until your specific layout is defined;
• Configure the settings of each speaker, the channel mapping to Dolby, DTS, Dolby Atmos, DTS:X and Auro-3D formats
and the output routing;
• Verify the routing of the speakers by playing pink noise on each speaker;
• If necessary, set some Parametric Equalizers (PEQs) on some speakers;
• Set an array of speakers (please see next chapter);
• Save the preset.
Each of these steps is described in detail in the following pages.