8. TROUBLE SHOOTING
- For any information or problem contact your area dealer or our technical service center. The
necessary interventions must be carried out by specialised technical personel.
- Before carrying out any fault service or maintenance work, please always TRUN OFF THE
SWITCH, UNPLUG POWER CABLE, WAIT FOR SAW BLADE TO COME TO STANDSTILL.
WARNING
-31-
Common
problems
cause
solutions
The device
stops or
does not
start
1. Motor overload, into protective status
1. Wait for the motor to cool and restart
2. Overload protection start
2. Reset the circuit breaker
3. The emergency stop button is pressed
3. Pull back the emergency stop button
4. The safety switch is not activated (the saw blade
cover is open)
4. Close saw blade cover
5. Power failure or factory power supply
5. Find out if the reason for the power failure of
the factory is missing
6. The fuse is burned and damaged
6. Replace the fuse
7. Use an unsharp saw blade or feed speed too quickly
and result in overload protection start
7. Wait for the motor to cool and restart or reset
the circuit breaker
8. Damaged wire cable or loose wiring
8.Replace cable or check wiring
Amounted
to less than
45 ° or 0 °
cutting
1. The saw blade has not searched for zero position
1. Researching the saw blade deviation
2. The adjustment of the zero-position switch of the
saw blade is incorrect
2. Adjust the position of the zero position switch
of the saw blade
Get stuck
on the
workpiece
when
entering
1. The saw blade is not sharp
1. Replace the sharp saw blade
2. Not match the blade thickness with the saw blade
used
2. Install the correct heel plate; The thickness
must be greater than the thickness of the saw
blade
The forming
size of the
workpiece
is not
consistent
with the
sawing width
1. The ruler is not accurate
1. Adjust the ruler by ruler
2. The baffle does not search for zero
2. Research for baffle zero
3. Adjustment of baffle zero deviation is incorrect
3. Change to the actual zero offset, and re-search
the baffle zero
4. Adjustment of baffle zero switch is incorrect
4. Reset the position of baffle position
When using
material
baffle, wood
and saw
card die
1. The material baffle is not parallel to the saw blade,
and the direction is reversed
1. Check and reset the parallelism
2. Timber bending
2. Replace a piece of wood
3. The feeding speed is too fast
3. Reduce feeding speed
4. Not parallel to blade and saw blade
4. Readjust the parallelism of the blade blade
relative saw blade
The cutting
effect is not
ideal
1. The saw blade is not sharp
1. Replace the saw blade
2. The saw blade is installed backwards
2. Reinstall the saw blade
3. The saw blade is not clean
3. Remove the saw blade and clean it
4. Use non-conforming saw blades
4. Replace the appropriate saw blade
5. The table is not clean
5. Clean the workbench
With a
slotting saw
1. The main saw and slot saw are not in a straight line 1. Adjust the position of slot saw blade
2. Slot saw blade is too narrow
2. Adjust slot saw blade height or replace slot
saw blade
The
workpiece is
warped with
a slotting
saw
1. Slot saw blade is not sharp
1. Replace the slot saw blade
2. Slot saw blade height is not enough
2. Adjust the blade height
