4.3 INSTALLATION ZONE REQUIRMENTS
A few elements will be disassembled from the machine main structure due to packaging and shipping requirements.
These loose parts should be installed as follows.
Please tighten all bolts and nuts absolutely. Otherwise, may cause machine wobble or serious injury to the operator or
other persons.
-14-
4.3
Fixing to the floor
The machine must be fixed to the floor.
- Use bolt/nut A to level the feet to ensure machine is well
located.
- Put expansion bolts D into ground, use washer/lock
wahser C and hex nut B to fasten the bolts.
A
B
C
D
A
C
B
1
2
3
1
2
3
H
G
F
A
B
C
D
K
J
I
E
4.4.2 INSTALL BLADE GUARD
Tools required
：
- 4mm socket head wrench
- 12mm socket head wrench
- 13-16mm wrench
- Install engineering bracket F to the main body with 4
bolts H and washer G.
- Cross the rotation axis B through washer C, CNC
computer A, engineering bracket F, tightening with washer
C and nut D.
- Then locating the connected cord attached with the CNC
computer to the groove of bracket F with cable buckle
E/I/J. Tighten it with screw K.
4.4.2
4.4.1
- It is prohibited to install the machine in explosive environments.
The installation zone must be selected evaluating the work space required depending on the dimension of the pieces
to be machined,and taking into account that a free space of at least 800 mm must be left around the machine.It is also
necessary to check The floor capacity and its surface, so that the machine base is evenly resting on its four supports.A
power outlet and a chip-suction system connection shall be closeto the selected machine setting and it must be
conveniently lighted (luminous intensity: 500 LUX).
WARNING
4.4 INSTALL OF LOOSE PARTS - INTRODUCTION
Tools required for assembly
- Wrench 16mm
- 6mm socket head wrench
Install rear subsidiary board A to main operating board
with bolt 1 and washer 2.
Install right subsidiary board B to main operating board
with bolt 1 and washer 2.
4.4.1 INSTAII EXTENSION TABLE
