- Click button in arrangement operation list, setup deburring size of raw material panel.
- Click button in arrangement operation list, setup length , width and thickness of raw material panel ; or
click button to choose collected raw material panel specification.
6.4.2 Design arrangement drawing
After starting up machine correctly, click into
arrangement operation panel (6.4.2) on main operation
panel (6.2)
●
Setup raw material panel
- Click button in arrangement operation list, setup
main blade edge width according to exact setting main
blade edge wide.
6.4.1
6.4.2
-29-
6.4 Cutting operation
Choosing cutting method is mainly according to wood
size and cutting technology. When cutting valuable wood
material, using scoring blade could help to avoid break
or burr. When not need scoring blade, please drop it to
bottom of table.
6.4.1 Manual cutting model
- After starting up machine, on operation panel (6.2),
click into manul operation panel (6.4.1).
- Click blade tilting ”Start Searching Zero Position”,
Blade lifting “Start Searching Zero Position” and Fence
“Start Searching Zero Position” button, when status line
in bottom of the screen show “ System work normally”,
machine begin to work normally.
- Prohibit putting down fence
- Prohibit using main blade with diameter over ø400
●
Set-up finished board
- Setup panel length and width in part operation list
;
Or choose
collected panel through click.
- Setup quantity of unit made-up articles panel through click button in part operation list.
- Click button to lead current length, width and quantity of panel to part operation list.
●
Create arrangement optimum proposal.
- Click button in arrangement operation list, Made-up articles list makeup optimazition according to raw
material panel size, and show on arrangement preview list.
- Click button in arrangement operation list, save the arrangement optimum proposal in folder of computer.
- Complete arrangement optimum proposal design
- After setting fence position, main blade lifting height and main blade titling angle on operation screen ( 6.4.1), you
could cutting wood material in normal manul method.
- Main blade lifting height also could be set up by main blade lift button F through panel button ( 6.1).
- Main blade tilting angle also could be set up by main blade tilt button G through panel button ( 6.1).
- Operator push wood material according to cutting demand.
WARNING
