7. MAINTENANCE
Disconnect the general power
supply before doing any
maintenance.
7.4 REPLACEMENT AND DISPOSAL
Should replacement become necessary, the machine
parts must be replaced with original components in
order to guarantee their efficiency.
-30-
7.1 REPACE SAW BLADE
7.3 GENERAL LUBRICATION
- Weekly clean and lubricate all the mobile couplings of
the machine A with a thin film of oil and grease.
- Protect all belts and pulleys to avoid contamination
with oil.
- Rotate the blade lifting handwheel to move the blade
to toppest position.
- Take out the blade guard A.
- Push the sliding table to backmost position.
- Open the blade cover D.
- Unscrew the nut C to take out the blade for
replacement.
Only correctly sharpened saw blades manufactured
in accordance with the requirements of EN 847-
1:2005 shall be used. Don’t use the saw blade whose
maximum marked speed is lower than the maximum
rotational speed of the saw spindle. Please always
keep the gap between the riving knife and the saw
blade to be at least 3mm and not exceed 8mm.
7.2 OVERALL CLEANING
Please DO NOT to try removing chips while the
saw blade is running.
After each working cycle, thoroughly clean the machine
and all of its parts, vacuum the shavings and dust and
remove any resin residues.
Use compressed air only when strictly necessary, using
protective glasses and a mask.
In particular, clean the following parts:
- the sliding table rail A;
- the sliding support extension B;
- In case of mechanical or functional faults in the machine, including guards or tools, please call
the local authorized agent for technical assistance and maintenance.
- Any maintenance must be only done when the machine is isolated from all energy sources
(plug out).
WARNING
C
A
B
7.1
WARNING
B
C
A
7.2
A
B
C
D
7.3
WARNING
The replaced parts must be disposed of in compliance with the laws in force in the country of use.
Component replacement requires specific training and technical skills; for this reason, the above interventions must be
carried out by qualified personnel to prevent damage to the machine and risks to the safety of persons.
CAUTION
