6.2.4.1
- Fence running speed( Set by manufactuer, unalterable)
- Fence acceleration
（
Set by manufactuer, unalterable
）
- Fence running speed when back to zero
（
Set by manufactuer, unalterable
）
- Main blade width
- Fence maximun stroke when rip cutting
（
Set by manufactuer, unalterable
）
- Raw material layout deburring width
- Change blade width, default deburring width
- Switch to board management
，
press to act
- Switch to parts management
，
press to act
- Add size to collection
- Delete current size collected
●
Cutting operation panel (6.2.4.1)
-28-
6.3.1
6.3.2
A
B
C D E
5000RPM 4000RPM 3000RPM
A- Locking handlebar
B- Speed regulating bolt
C/D/E-3000/4000/5000RP moptoelectronic switch
- Tools required
- T-type internal hexagon wrench
-Firstly, elevating the saw blade to the highest location,
then take off the cover from the worktable
- According to the direction from 6.3.1, pull up locking
handlebar A, and rotate speed-regulating bolt B along
clockwise, last loosen belt.
- When replace the belt, take out the old one and add
a new one, then rotate speed-regulating bolt B along
anticlockwise.
- When regulate the speed, put the belt on the proper
position, tighten the belt and lay down the worktable
cover-
-Speed of main blade 0000 shows discrepancy to the
practice, turn the induction knob on optoelectronic switch
C/D/E ( 6.3.2) to regulate photoelectric induction distance.
- Ensure pre-regulating speed of main blade is lower than
the fastest safety speed.
- Periodic cleaning the powder inside of optoelectronic
switch C/D/E to ensure best working status.
6.3 Replace belt and adjust rotate speed
WARNING
