5.5 DIGITAL READOUT ADJUSTMENT
Operation of Digital readout cross cutting fence contains parameters setting panel and operating panel. All signals are inputted by 4
buttons on operation panel and displayed on screen by LED built-in.
5.5.1 Overview-Display
The following display icons or segments of the LCD-display are
used in this software version.(5.5.1)
1-Segments for numeric and text display(including signs, decimal
points, fraction display)
2-Symbols for units and display mode
3-Icons for active tool-offsets 1 ... 3
4-Battery-Status Icons
5-REF symbol: unit needs to be referenced
-For different applications the symbol may be changed for the
unit by parameterP02.
-The standardization of the indicator value must be done
manually with the corresponding multiplication factorP08 and the
decimal pointP03.
-In the Inch-mode an additional fraction display is available.
5.5.1
5.5.2
5.5.3.1
5.5.3.2
5.5.3.3
5.5.2 Key overview
The function of the keys in the parameter level is shown on
the button in the dark box on the left below, thefunction at the
operating level is shown in the bright field size.
(5.5.2)
5.5.3 Parameter Level
5.5.3.1 Activate the Parameter Level
- Hold for about 3 seconds/ then press each 1x.
- The parameter level is activated with this key. After about 3
seconds the display shows „P01“for the firstparameter. When the
button is actuated again, the corresponding parameter value is
displayed, which can thenbe changed. With the help of this all
parameters are successfully selected.(5.5.3.1)
5.5.3.2 Election of the Decade
-1x pressed
-With this key the decade will be advanced by a passage from
left to right. The selected, changeable decade isflashing on the
display.(5.5.3.2)
5.5.3.3 Change Value
-1x pressed
-With this key the value in the selected decade is always
increased by 1 (0…9or 0/1)(5.5.3.3)
-19-
