-31-
6.5 CORRECT USE FOR THIS MACHINE
- First make sure that the machine does not vibrate.Do
not try to take off the material when the cut has already
started; proceed with a continuous and uniform speed.
workpiece feeding towards the blade (especially where
there are knots) should not be too fast (feeding speed
should be in accordance with workpiece thickness). Do
not let workpieces stop between the saw fence and the
blade.
- Avoid contact of the tips against metallic objects.
When necessary sharpen the saw blade.Often clean
the steel body and the tips with proper liquid products.
Let the saw blade in the bath, then clean it with brush:
don’t use metallic brushes. As regards the toothing at
least 2-3 teeth shall cut at the same time A. If only one
tooth cuts B, you don’t get a good cutting. Whenever this
is possible, it is also critical to lift the blade until the whole
tooth cutting part protrudes from the wood thickness.
6.5
A
B
5mm
5mm
Before touching the machine parts, ensure to turn off the
main switch and disconnect the general power supply.
4
2
3
1
、
5
6.6
WARNING
Before cutting party should guarantee the sliding table and
guiding rule adjustment in place, you should use sharp
quality assured saw blade, choose a 1000 mmx1000mm
particieboard or density board, 19 mm thickness is greater
than the last saw trimming will be tight on the guiding
rule, plank counterclockwise, each 10 mm, cutting 5
times, check the 5th after cutting wood width, requires the
allowed tolerance shall not be more than 0.2 mm.
6.6 The adjustment of the machine after the
cutting party inspection
