Toshiba MMC-AP0151H, Руководство по обслуживанию

Страница: 257 / 270

257
Push claw side against the rubber.
Compress rubber and make margin.
Push in the band toward arrow mark.
Align direction of the slits,
and then attach to each pipe.
Matching the claws, slide them.
Align the claw to slit side of the rubber.
Push the band against
rubber without clearance.
Slide the square hole side
toward arrow mark.
Slide it.
1)
2)
1)
2)
3)
4)
1)
No.
8
Part to be
exchanged
Attachment/
detachment of
pipe fixing
rubber
Work procedure
REQUIREMENT
Put on gloves during working; otherwise an
injury may be caused by parts, etc.
<Disassembling>
1) Hold the both ends (longitudinal direction)
of the rubber lightly, and then make a
margin between SUS band and fixing
rubber.
2) Pushing in the claw side of SUS band with
fingers, the claw comes off from the square
hole.
Remarks
<Assembly>
1) The fixing rubber is a segmentation system
due to freedom degree of combination.
Therefore, for assembly, it is recommended
to fit both pipes including the fixing rubber
after passing the rubber through the pipes
separately. In this time, check both slit direct
the same direction.
2) Align the claw side of SUS band to slit side
of the rubber for assembly. (Assembly in
reverse direction is also available, but the
work performance decreases.)
3) Attach the band so that a clearance does
not generate between SUS band and fixing
rubber. Especially pay attention not to
generate a clearance at part of the hair pin
side of the band.
4) Fit the root of claw to the rubber lightly,
push R part at square hole side toward the
arrow mark, and then hook the claw to the
square hole.
(If it is not hooked, recheck 3) there is no
clearance between band and rubber.)