Toshiba DeviceNet nv Series, Инструкция по эксплуатации, Страница: 39 / 159

3.5 Connecting the DeviceNet transmission cable
Unified Controller nv Series DeviceNet Module DN611B Instruction Manual
23
3.3
Installing and Removing the Module
DN611B is a 1-slot width type of type1 light module.
For the DN611B, install and remove the module, paying attention to the items described in the
"Installing/removing the module" section of the "Unified Controller nv series type1 light Controller Unit User’s
Manual - Basic Hardware" (6F8C1497).
Please follow the instructions in the "Installing/Removing the Module" section of the "type1 light Controller Unit
Instruction Manual" (6F8C1497).
Make sure that the power is off before installing / removing
the device.
There is a risk of electric shock.
Mandatory
Please install and wire after removing static electricity
from human body.
Product may be damaged by the static electricity charged
on the human body.
Mandatory
When connecting the cable to the product, do not break
or bend the pins of the TC-net I/O bus connector.
It may cause malfunction or failure.
Prohibited
Please use the + driver.
Please use the screwdriver matched the screw to prevent
damage to the screw.
Mandatory
Module insertion and removal should be done within
50 times after starting use
Failure to do so may cause failure or characteristic
degradation.
Mandatory
The maximum current consumption of DN611B is 1200mA. Make sure that the power supply capacity per base
unit does not exceed the rated output of the power supply module.
For the calculation of the power supply capacity per base unit, refer to "Power Supply Capacity Calculation" in
the "type1 light Controller Unit Instruction Manual" (6F8C1497).