Toro 41107-210000101, Руководство оператора и инструкция по установке

Страница: 40 / 80

40
Inspect hydraulic lines and hoses daily for leaks,
kinked lines, loose mounting supports, wear,
loose fittings, weather deterioration, and chemical
deterioration. Make all necessary repairs before
operating.
CLEANING TRANSAXLE/HYDRAULIC
STRAINER:
Clean Transaxle/Hydraulic Strainer every 800
operating hours.
1. Park the vehicle on a level surface, stop engine,
engage the parking brake and remove key from
ignition switch.
2. Remove drain plug from side of reservoir and
let Transaxle/Hydraulic Fluid flow into drain pan.
(See FIG. 26)
3. Note orientation of hydraulic hose and fitting.
Remove transaxle/hydraulic hose and fitting.
4. Remove strainer and clean by back flushing
with a clean degreaser. Allow to air dry before
reinstalling.
5. Reinstall strainer.
6. Reinstall transaxle/hydraulic hose and fitting
to strainer in same orientation.
7. Reinstall and tighten drain plug.
8. Fill reservoir with approximately 7.5 qt. of
Dexron III ATF. To check the Transaxle/Hydraulic
Fluid see Before Operating, page 18.
PRESSURE SETTINGS:
The pressure relief valve used in the MULTI PRO ®
1200 are all factory preset at 1000 psi and cannot
be readjusted.
NOTE: To check the Transaxle/Hydraulic Fluid,
see Before Operating, page 18.
HYDRAULIC SYSTEM MAINTENANCE
Pin hole leaks can eject high
pressure hydraulic fluid. Hydraulic
fluid escaping under pressure can
penetrate skin and cause injury.
Fluid accidentally injected into the skin
must be surgically removed within a
few hours by a doctor familiar with this
form of injury or gangrene may result.
Wear gloves and use cardboard or
paper to find hydraulic leaks. Never
use your hands.
CAUTION
CHECKING HYDRAULIC LINES AND
HOSES:
1775
1. Dipstick 3. Drain Plug
2. Strainer
FIG. 26
2
1
3