Toro 41107-210000101, Руководство оператора и инструкция по установке

Страница: 12 / 80

12
4. Position a Spacer Tube between the lugs on
each side of the Main Frame tube. Insert a 1/2" x
2-3/4" Grade 8 cap screw through the lugs and
spacers. Secure the Main Frame to the Boom
Mounting Brackets with flange nuts. Torque to
105 ft lbs. (142 N-m) (See FIG. 3)
2. Main Frame Tube 4. Boom Support Strap
FIG. 3
5. Using a torque wrench, tighten the 1/2" x 18"
screw that joins the Wedges to the Boom Mounts.
Tighten to 50 ft. lbs (68 N-m).
6. Position the two (2) Center Boom angles on
the Main Frame and secure them to the Main
Frame Tube with two (2) square U-bolts, four (4)
flat washers and hex nuts. (See FIG. 4, page 13)
1801
CAUTION
Chemicals are hazardous and can
cause personal injury!
Securely tighten all sprayer hose
clamp connections during intial set-up
to prevent leaks and hose blow-offs
while spraying system is in operation.
SPRAY SYSTEM:
Note: In the following instructions, "sealer",
refers to the Teflon Thread Tape.
NOTE: If optional Hose Reel is to be
installed on unit; install Hose Reel before
installing Boom. See Set-Up and Parts
Manual supplied with Hose Reel.
1. Remove Stop Pins in Boom Mount Assemblies.
Apply a heavy coating of grease to the tubes of
the two (2) Boom Mount Assemblies and insert
them into the Vehicle Frame until Angled Gusset
bottoms out against Vehicle Frame. (See FIG. 1)
1. Stop Pin 3. 1/2" x 18" screws
2. Boom Mount ASM
FIG. 1
NOTE: If installing the "Enclosed Boom"
option in place of the Standard Boom, skip
steps 2-20 - See Enclosed Boom Instructions.
2.
Install the two (2) Boom Hold-In Assemblies
to the top of the Boom Mount uprights as shown
in FIG. 2, using four (4) 1/2" x 1-1/4" cap screws,
and flange nuts.
SETUP INSTRUCTIONS
3. Attach the two (2) "U"-shaped Boom Mounting
Brackets to the third and fourth holes from the
top of the Boom Mount uprights with four (4) 1/
2" x 1-1/4" cap screws, and flange nuts. Torque
to 75 ft-lbs (102 N-m).
1802
FIG. 2
1. Boom Hold-In ASM 2. Boom Mount Uprights
1. Spacer Tube 3. Boom Mounting Brackets
2
1813-1200
1