Toro 41107-210000101, Руководство оператора и инструкция по установке

Страница: 19 / 80

19
NEUTRAL SWITCH:
The Multi Pro
®
1200 is equipped with a Neutral
Switch. The purpose of this switch is to ensure
that the vehicle will not start and the Accelerator
Lock will not engage unless the Range Selector
is in the NEUTRAL position.
The Neutral Switch is located underneath the Left
Control Panel and is accessed by removing the
Air Cleaner Cover. (See FIG. 9)
Check and maintain the Neutral Switch in a
position that prevents the engine from starting
unless the range selector is in the neutral position.
BEFORE OPERATING
Note: For Neutral Switch Maintenance, see
Maintenance, page 29 .
WARNING
If the engine can be started or the
Accelerator Lock can be set without the
Range Selector in the Neutral Position,
the Neutral Switch circuit is faulty. DO
NOT OPERATE THE VEHICLE!
FIG. 9
1. Neutral Switch
2. Air Filter
1884
CHECK TORQUE OF WHEEL NUTS:
Failure to maintain proper torque could
result in failure or loss of wheel and may
result in personal injury.
Torque front wheel nuts to 55-65 ft-lb (75-
88N-m) and rear wheel nuts or bolts to 45-
65 ft-lb (61 TO 88 N-m) after 1-4 hours
of operation and again after 10 hours
of operation and every 200 hours
thereafter.
WARNING
WARNING
Brake failure can cause loss of
control and result in serious injury or
death.
Test Brake function and correct before
operation.
IMPORTANT! After the "initial run-in"
(approximately one to two hours), check all the
MULTI PRO
®
1200 wheel fasteners for
tightness.
CHECK TIRE PRESSURE:
Check tire pressure every 8 hours or daily to
assure proper levels. Maximum air pressure in
both front and rear tires is 18 psi.
The air pressure needed is determined by the
payload carried. Once the desired pressure has
been ascertained, it is to be used and maintained
as a factor in the computer programming to
insure the accuracy of the spraying system.
INSPECT TIRES:
Check tire condition for wear or damage.
Operating accidents, such as hitting curbs, can
damage a tire or rim and also disrupt wheel
alignment; so inspect tire condition after any
accident.
Note: Your MULTI PRO ® 1200 is supplied with
self-adjusting brakes. Replace brakes when worn.
See the 104-8754 MULTI PRO
®
1200 Parts Manual
for replacement. For Emergency/Parking Brake
Maintenance, see page 42.
1
2
3
3. Shield Panel L.H.