Thermo Scientific Surveyor PDA Plus, Руководство по оборудованию

Страница: 31 / 136

2
Installation
Making the Back Panel Connections
Thermo Scientific Surveyor PDA Plus Detector Hardware Manual 11
Making the Back Panel Connections
Use the cables provided in the Surveyor system accessory kit to make the connections to the
back panel of the detector. The part numbers for these cables are listed in
Table 6 on
page 104 .
See “Turning On the Detector for the First Time” on page 19 for instructions on connecting
to line power.
This section contains the following topics:
• Connecting the Ethernet Cable
• Connecting the Interconnect Cable
• Connecting the Analog Outputs
• Setting the Analog Output Voltage
• Setting the Unit ID
Connecting the Ethernet Cable
Connect the Ethernet switch to the Ethernet connector port of the PDA detector using the
supplied CAT5, 7 ft. long, shielded Ethernet cable with ferrite clamp.
Connecting the Interconnect Cable
The interconnect cable coordinates the timing of the Surveyor Plus modules during an
injection sequence. There are two versions of this cable. The previous version of the cable,
which you might have in your laboratory, contains five connectors labeled as follows: DET,
M/S, A/S, LC PUMP, and MS PUMP.
Figure 9 shows the new version of the interconnect
cable, which contains the following: three detector connectors labeled DETECTOR, two
pump connectors labeled PUMP, an autosampler connector, and an MS detector connector.
Figure 9. Seven-connector version of the system interconnect cable
DETECT
OR
DETECT
OR
DETECT
OR
PUMP
PUMP
A/S
M/S
Autosampler
connector