Thermo Scientific MIRAN 205B Series, Инструкция по эксплуатации

Страница: 74 / 214

Chapter 7 Configuration and Setup
7-20
Locations
To configure the locations, press
3
(Location List) from the Analysis Setup Page 3. The
Location Menu, shown below, is displayed.
┌────────────────────────────────────────┐
│╒═══ LOCATION SUMMARY ════╕ LOCATION MENU │
││ Mode: Enabled │ 1=Mode │
││ │ │
││ Ordering: As entered │ 2=Order of list │
││ │ │
││ Insert: Alphabetical │ 3=How to insert │
││ │ new locations │
│└───────────────────────┘ into list │
└────────────────────────────────────────┘
Location Menu
Press
1
to select the location mode. At the next display, press
1
to turn the location
function Off or press
2
to Enable the function. The display responds "-ACCEPTED-."
To gain access to the list of stored locations or to add locations during logging, enable the
Location Mode. Enabling the Location Mode results in item 3, 4, and 5 being added to
the analysis menu during run mode.
Press
2
to configure how the location list is sorted. At the next display, press
1
to sort as
entered or press
2
to sort alphabetically. The display responds "-ACCEPTED-."
Press
3
to specify where to insert a new location. At the next display, press
1
to select
Not allowed, 2 to insert alphabetically, 3 to insert at list end, or 4 to insert above current
location. The display responds "-ACCEPTED-." Refer to Chapter 8, “Site Info” for
more information about sites and locations.
Report Output
The Report Output parameter configures certain features of the report output. To access
this feature, press
4
from the third Analysis Setup Menu. Upon presentation of the report
output display, press
1
to select the report output mode,
2
to select the report location
order
, 3
to select the locations reported, or
4
to select if duplicates are to be reported.
If
1
is pressed to select the report output mode, press
1
again to choose the “As Logged”
mode or
2
to choose the “By Location” mode.
Note:
If 1 is selected and data was not logged to locations, no site report data will be
output.
If
2
is pressed to select the report location order, press
1
to choose “As Entered” or
2
to
choose “Alphabetical.”