Thermo Scientific Dionex, Руководство оператора

Страница: 149 / 228

10 • Service
Doc. 065250-06 03/2020
137
6. A label on the valve mounting plate identifies the number of the valve.
Disconnect the valve cable from its corresponding connector on the main SP
electronics board (see
Figure 10-11 ).
For example, the SS valve is
SV5
. If you are replacing an SS valve, disconnect
the cable from connector
SV05
.
7. Remove the cable from the cable organizer.
8. Loosen the captive thumbscrew on the valve mounting plate and remove the
valve from the SP panel.
9. Carefully pull the cable out through the front of the SP.
10. Thread the cable from the new solenoid valve (P/N 068554) through the
opening on the SP panel and route the cable to the main SP electronics board.
11. Insert the two tabs on the new valve mounting plate into the slots on the SP
panel.
12. While holding the valve mounting plate firmly against the SP, tighten the
captive thumbscrew.
13. Plug the valve connector into the main SP electronics board (see
Figure 10-11 ). Secure the cable in the cable organizer.
Figure 10-11. Main SP Electronics Board: Solenoid Valve Cable Connections
Solenoid Valve
Cables (8)
SV01
SV03
SV05
SV07
SV02
SV04
SV06
SV08
Cable
Organizer