Thermo Scientific Dionex, Руководство оператора

Страница: 64 / 228

Dionex Integral Systems Operator’s Manual
52
Doc. 065250-06 03/2020
4. Thread the flow sensor’s cable through the slot in the mounting panel.
5. Follow the instructions in Section 10.7 to access the main SP electronics
board.
6. Plug the cable into the connector labeled
FLOW 1
(or
FLOW 2
, if this is the
second sensor) in the bottom center of the main SP electronics board (see
Figure 3-32 ).
7. Use the tubing and fittings provided in the kit to connect an inlet line and
outlet line to the flow sensor. (There is no prescribed flow direction; liquid
can enter and leave the flow sensor from either side.)
8. Close and secure the SP service door.
9. If you removed the SP from the AE rear panel:
a. Lift up the SP, align the four hooks on the rear of the SP with the
mounting rails on the AE rear panel, and hang the SP on the rails.
b. Replace any modules that were removed from the lower shelf of the AE.
c. Replace the two access panels on the exterior of the AE.
10. Plug in the power cord and turn on the power.
11. Open the Chromeleon 7 Instrument Configuration Manager and open the SP
Properties dialog box. The Flow Sensor_1 (or Flow Sensor_2 ) check box is
enabled on the Sensors page. Enter the low and high flow limits.
Figure 3-32. Main SP Electronics Board: Flow Sensor Connectors
Flow Sensor Connectors