Thermo Scientific Dionex, Руководство оператора

Страница: 133 / 228

9 • Troubleshooting
Doc. 065250-06 03/2020
121
9.5 System or System Component Does Not Power Up
•
AE main power cord not connected
Make sure the power cord is connected from the power in connector (on top
of the AE) (see
Figure 5-4 ) to the main power receptacle.
•
AE main power turned off
1. Make sure the power switch on the top of the AE is on (see Figure 5-6 ).
2. Make sure the
Emergency Off
switch on the AE front door is not pushed
in. If necessary, twist the knob on the switch clockwise and pull out to
return the switch to the on position and restore power.
•
System component power cord not connected
Make sure the component’s power cord is connected to the appropriate AC
outlet. The power strip inside the AE (see
Figure 5-3 ) provides AC outlets for
components installed inside an AE or mounted on the side of an AE.
•
System component power switch is off
Make sure the component’s power switch is in the on position. Leave the
switch on unless instructed to turn it off (for example, before performing a
service procedure).
If the component is installed inside an AE or mounted on the side of an AE,
use the main power switch on the top of the AE (see
Figure 5-6 ) to control
power to all connected components.
Electrical system circuits carry dangerous voltages. Disconnect all
power before working on them.
Les circuits du système électriques ont des tensions dangereuses.
Débranchez toute l'alimentation électrique avant de travailler sur les
circuits.
Elektrische Schaltkreise führen gefährliche Spannungen. Entfernen
Sie alle Stromversorgungen, ehe Sie daran arbeiten.