Thermo Scientific Dionex, Руководство оператора

Страница: 121 / 228

9 • Troubleshooting
Doc. 065250-06 03/2020
109
This error occurs if the slope value is out of the expected range when the flow
sensor is being calibrated.
To troubleshoot:
1. Review the calibration procedure and then rerun the calibration (see
Section 10.10 ).
2. If the problem persists, contact Technical Support for Dionex products for
assistance.
The Leak sensor 1 wet error occurs when liquid accumulates in the drip tray
in the bottom of the SP, or when the leak sensor is not connected.
The Leak sensor 2 wet error occurs when liquid accumulates in the drip tray
in the bottom of the AE.
To troubleshoot:
1. Locate the source of the leak by visually inspecting tubing, fittings, and
components in the SP or AE.
Flow sensor 1 slope calibration value is out of range
-or-
Flow sensor 2 slope calibration value is out of range
Leak sensor 1 wet
-or-
Leak sensor 2 wet
If leaking liquid creates a hazard, stop the leak immediately by turning
off the flow at the source.
Si une fuite de liquide crée un danger, arrêtez immédiatement la fuite
en fermant l'écoulement à la source.
Wenn eine Gefährdung durch austretende Flüssigkeit besteht,
stoppen Sie die Leckage unmittelbar, indem Sie den Fluß an der
Quelle abstellen.