disable
link
ping
speed
Example:
config autorestart port 1-4 state link
2. IP cameras on the port (if control by PING is selected)
config autorestart port <PORTLIST> host <IP>
Example:
config autorestart port 1-1 host 192.168.0.13
3. Minimum speed on the port (if Speed is slected) in Kbps.
config autorestart port <PORTLIST> min_speed <VALUE>
Example:
config autorestart port 1-1 min_speed 3
5.4.3.11 Configuring dry contacts (digital inputs)
There are inputs in the command system with ordinal numbers 0-2.
Input 0 – tamper sensor on the cover of TFortis PSW-2G + and TFortis
PSW-2G6F + switches. Input trigger level cannot be changed.
Input 1 – main input used to connect user sensors, it is marked "Sensor
1" of the switch board
Input 2 – an additional input, can also be used to connect sensors, but
does not have protection, like Input 1, marked "Sensor 2" on the switch
board.
In general, the following commands are applicable for inputs:
1. Enable input operation (i.e., triggering an input causes
an event to
occur that can be sent in a specified way, for example, Syslog)
config dry_cont <NUM> state <STATE>
where
:
<NUM>
– input number
<STATE>
– state
Example:
config
dry_cont
1 state enable
2. Selecting an input state that is considered an alarm and
an event is
generated
config dry_cont <NUM> alarm_level <STATE>
where:
<NUM>
– input number (0-2)
<STATE> –
a state that is considered an alarm:
short
– cloased state
open
— open state
