Let's see an
example
:
When the inputs of Sensor 1 and Input 1 are closed, an event occurs.
Figure 5.3.34.3 Configuring logic
It is necessary that the relay, which is normally closed, opens when an event occurs.
Set the
Initial State
to
Short
(closed) and select the event sources (Sensor 1 and
Input 1) and the output state (
Action
)
Figure 5.3.34.4 Configuring logic
5.3.34.4 RS485 output
Special Function → RS-485
The expansion board has a built-in RS485 output, intended for connecting
additional devices via the RS485 interface. At the moment, only metering devices are
supported. Before connecting a remote device, it is necessary to configure the
interface.
