TEUPEN LEO 27T, Перевод инструкции по эксплуатации

Страница: 216 / 312

Faults
216
07/05/2018
Code Description
1 Software error / hardware error.
2 Software error / hardware error.
3 Software error / hardware error.
4 Microprocessor hardware fault.
5 Check the inputs for ground pressure for outrigger 1.
6 Check the inputs for ground pressure for outrigger 2.
7 Check the inputs for ground pressure for outrigger 3.
8 Check the inputs for ground pressure for outrigger 4.
9 Check inputs for the "Braced wide" position switch, outrigger 1.
10 Check inputs for the "Braced wide" position switch, outrigger 2.
11 Check inputs for the "Braced wide" position switch, outrigger 3.
12 Check inputs for the "Braced wide" position switch, outrigger 4.
13 Check safety relay 1, monitoring contact.
14 Check safety relay 2, monitoring contact.
15 Check safety relay 3, monitoring contact.
16 Check safety relay 4, monitoring contact.
17 Check inputs for the "Telescopic boom placed" position switch.
18 No position switches for outrigger height should be pressed if during the switch on of the control it is de-
tected that outriggers are not locked.
19 Joystick 1 on the cable remote control was moved during start-up or is faulty.
20 Joystick 2 on the cable remote control was moved during start-up or is faulty.
21 The joysticks on control panel were moved during start-up or are faulty (release contact).
22 The joysticks on the cable remote control were moved during start-up or are faulty (release contact).
23 Joystick 1 on the control panel was moved during start-up or is faulty.
24 Joystick 2 on the control panel was moved during start-up or is faulty.
25 Joystick 3 on the control panel was moved during start-up or is faulty.
26 Joystick 4 on the control panel was moved during start-up or is faulty.
27 Button 1 of the cable remote control was either pressed or is defective.
28 Button 2 of the cable remote control was either pressed or is defective.
29 Button 3 of the cable remote control was either pressed or is defective.
30 Button 4 of the cable remote control was either pressed or is defective.
31 The toggle switch to activate the basket rotation movement on the cable remote control was pressed or is
defective.
32 The toggle switch to activate the movement on the cable remote control was pressed or is defective.
33 The toggle switch to activate the automatic bracing on the cable remote control was pressed or is defect-
ive.
34 One of the toggle switches for setting the basket level has been actuated or is faulty.
35 Voltage was applied on the output side when switching on the machine or an output driver is faulty.
36 The voltage of the back-up battery is more than 4 V. Replace the battery or there is a hardware fault on
the controller.
37 The supply voltage has dropped below 17 V.
38 The supply voltage has exceeded 32 V.
39 The measured angle must not exceed a certain value whilst the telescopic boom is applied. The position
switch might be stuck in the bracket.
40 The "Chassis release" relay must be checked.