TEUPEN LEO 27T, Перевод инструкции по эксплуатации

Страница: 127 / 312

Operation
07/05/2018 127
7.16.1 Moving the bracing into transport position manually
1. Switch on the machine ( Ä Chapter 7.3 „Switching the machine on/off”, on page
73).
2. Move the platform assembly into transport position ( Ä Chapter 7.15 „Moving the
platform assembly into transport position”, on page 123).
3 4 1 2
5 6
Fig. 149
3. Set the function selector to [bracing function] (yellow) (Fig.149/5).
WARNING
Risk of material damage due to improper use of the collision
button!
When adjusting the outriggers manually, you need to keep the collision button
pressed to enable movements. This can cause substantial damage to the machine!
– Make sure that no machine parts can be damaged during any movements.
– If there is a risk of collision, immediately release the collision button.
4. Press and hold the collision button (Fig.149/6).
5. Use the control levers (Fig.149/1, 2, 3 and 4) to move the desired outrigger(s)
as shown in the following table.
WARNING
Risk of injury from uneven lifting or lowering the machine!
Due to uneven lifting and lowering, the machine can tip or slide. This can cause
severe injuries and significant material damage.
– If the machine begins to list during lifting or lowering, immediately stop the
process and realign the machine manually.