TSP Edge User’s Manual
40-400-00065, Rev. E
109
Stop Transmit
The
Stop Transmit
will stop the sending of a wave file or tone from a channel, or
disconnect the transmitter of a channel from its Route Channel.
Establishing Audio Connections between Channels
Before an audio connection can be established in a script, channels must be identified
as Route Channel pairs. Route Channels may be established statically by
programming the assignments within the control set (control set type “User Script –
Fixed Pairs”), or dynamically by dialing the phone number for any other channel in
the control set (control set type “User Script – Dialed”). Dynamically paired Route
Channels remain paired until both channels use a
Post Current State
command to
indicate a Disconnect.
In a script, a
Connect Channels
command is issued to connect the transmitter of a
channel to the receiver of its Route Channel, and the receiver of the channel to the
transmitter of its Route Channel.
Either channel may initiate the process to disconnect. A channel issues a
Stop
Transmit
command, which will disconnect its transmitter from the receiver of its
Route Channel. The channel should then issue a
Signal Route Channel
command
(with message = Disconnect) to inform its Route Channel that it has disconnected.
The Route Channel should be monitoring for this message in its script, and should
then issue its own
Stop Transmit
command to disconnect its transmitter.
Содержание TSP Edge
Страница 1: ...TSP Edge User s Manual 40 400 00065 Rev E ...
