Tektronix Phaser 600, Руководство по обслуживанию

Страница: 84 / 286

3-10
Phaser 600 Color Printer
3
Verifying the Printer and Host Connections
VMS
To print to the Phaser 600 printer in the VMS environment, you must have the
symbiont PhaserSym running on the host. To print to the printer from the host,
you must first have the printer’s queue established. This is site-dependent and
requires the aid of the site’s network administrator. When the queue is in place,
you can proceed to the next step.
1. To verify the VMS host-to-Phaser 600 connection, use the NCP LOOP
CIRCUIT
command from the host.
2. From the host, issue the SHOW QUEUE /full command to list all the
available printer queues. Ensure that the Phaser 600’s queue is listed.
3. Print to the printer by sending the command:
print/queue= <queue name> <file.nam>
where <queue name> is the printer’s queue and <file.nam> is any
PostScript file.
Using the Error Handler utility
If the workstation host does not print to the printer, reset the printer and then
load the error handling utility into the printer’s memory using the menu item
Printer Defaults — PS Error Handler
.
Alternatively, reset the printer and then download the Tek Error Handler utility
to the printer.
1. Locate the TEKEHAND.PS file in the PHSR600 directory on the Printer
Utility diskette.
2.
Copy the TEKEHAND.PS file to the workstation's hard disk or use the
file from the diskette.
3. Make sure that the printer port is configured to receive PostScript,
then send the file to the printer.
This loads the error handling utility into the printer's memory where it remains
until the printer is turned off. Send a print file to the printer as explained in the
previous procedure. If an error occurs, it will print a page listing the error.