TECO-Westinghouse EQ7 Series, Инструкция по эксплуатации, Страница: 74 / 248

4-5
Code Name Data setting range
C
ha
nge
w
hen
run
ning
D
a
ta
c
op
y
in
g
Default
setting
Drive control
Refer to
Page
V/f
Vector
Control
w/
PG
Torque
control
w/o
PG
F37 Load Selection/
Auto Torque Boost/
Auto Energy Saving Operation 1
0: Variable torque load
1: Constant torque load
2: Auto torque boost
3: Auto energy saving
(Variable torque load during ACC/DEC)
4: Auto energy saving
(Constant torque load during
ACC/DEC)
5: Auto energy saving
(Auto torque boost during ACC/DEC)
N Y 1 Y N Y N 4-56
F38 Stop Frequency(Detection mode) 0: Detected speed 1: Reference speed N Y 0 N N Y N 4-58
F39 (Holding Time) 0.00 to 10.00 s Y Y 0.00 Y Y Y N
F40 Torque Limiter 1-1 -300% to 300%; 999 (Disable) Y Y 999 Y Y Y Y
F41 1-2 -300% to 300%; 999 (Disable) Y Y 999 Y Y Y Y
F42 Drive Control Selection 1 0: V/f control with slip compensation
inactive
1: Dynamic torque control
5: Vector control without speed sensor
6: Vector control with speed sensor N Y 0 Y Y Y Y
4-65
F43 Current Limiter (Mode selection) 0: Disable (No current limiter works.)
1: Enable at constant speed (Disable during
ACC/DEC)
2: Enable during ACC/constant speed
operation Y Y 2 Y N N N
4-67
F44 (Level) 20% to 200% (The data is interpreted as
the rated output current of the inverter for
100%.)
Y Y *5 Y N N N
F50 Electronic Thermal Overload Protection for
Braking Resistor
(Discharging capability)
0 (Braking resistor built-in type), 1 to 9000
kWs,
OFF (Disable) Y Y1 Y2 *6 Y Y Y Y
4-68
F51 (Allowable average loss) 0.001 to 99.99 kW Y Y1 Y2 0.001 Y Y Y Y
F52 (Resistance)
0.01 to 999Ω
Y Y1 Y2 0.01 Y Y Y Y
F80 Switching between LD, MD and HD drive
modes
1: LD (Variable Torque mode)
2: MD (Constant Torque mode)
0: HD (CT-Vector mode) N Y 1 Y Y Y Y
4-69
The shaded function codes are applicable to the quick setup.
*1 6.00 s for inverters of 40 HP or below; 20.00 s for those of 50 HP or above
*2 The motor rated current is automatically set. See Table B (P03/A17).
*3 5.0 min for inverters of 40 HP or below; 10.0 min for those of 50 HP or above
*4 0% to 100% for inverters of 7.5 HP or below
*5 160% for inverters of 7.5 HP or below; 130% for those of 10 HP or above
*6 0 for inverters of 15 HP or below; OFF for those of 20 HP or above
The shaded function codes are applicable to the quick setup.
Y: Applicable / N: Not Applicable.