Instruction Manual
ITEM TE700
TECNA
S.p.A.
52/128
LIM E MIN
This parameter defines a minimum energy limit value. Each time a weld is carried out the
control unit checks that the energy supplied by the welder is greater than the value set in this
parameter. Otherwise an error condition occurs (see the specific paragraph).
Activate this parameter by setting the CONTROL MODE to ENE, otherwise the parameter is
not displayed during the programming phase. The display of this parameter depends on the
configuration of the machine set in the
FEATURES
INVERTER
and
FEATURES TE700
menus
.
LIM E MAX
This parameter defines a maximum energy limit value. Each time a weld is carried out the
control unit checks that the energy supplied by the welder is less than the value set in this
parameter. Otherwise an error condition occurs (see the specific paragraph).
Activate this parameter by setting the CONTROL MODE to ENE, otherwise the parameter is
not displayed during the programming phase. The display of this parameter depends on the
configuration of the machine set in the
FEATURES
INVERTER
and
FEATURES TE700
menus
.
THICK MIN
This parameter defines a lower limit as concerns the minimum thickness of the material in
between the electrodes. Before the welding begins, the measurement of the thickness of the
material in between the electrodes must be greater than the set minimum limit. Otherwise an
error condition occurs (see the specific paragraph).
Activate this parameter by setting QUALITY-T. to THICK or TH+ID, otherwise the parameter
is not displayed during the programming phase. The display of this parameter depends on the
configuration of the machine set in the
FEATURES
INVERTER
and
FEATURES TE700
menus.
THICK MAX
This parameter defines an upper limit as concerns the maximum thickness of the material in
between the electrodes. Before the welding begins, the measurement of the thickness of the
material in between the electrodes must be less than the set maximum limit. Otherwise an
error condition occurs (see the specific paragraph).
Activate this parameter by setting QUALITY-T. to THICK or TH+ID, otherwise the parameter
is not displayed during the programming phase. The display of this parameter depends on the
configuration of the machine set in the
FEATURES
INVERTER
and
FEATURES TE700
menus
.
IDENT MIN
This parameter defines a lower limit as concerns the minimum electrodes penetration at the
end of the welding procedure. At the end of the welding operation the measurement of the
penetration value must be greater than the set limit. Otherwise an error condition occurs (see
the specific paragraph).
Activate this parameter by setting QUALITY-T. to IDENT or TH+ID, otherwise the parameter
is not displayed during the programming phase. The display of this parameter depends on the
configuration of the machine set in the
FEATURES
INVERTER
and
FEATURES TE700
menus
.
