BAG C (Continued)
Step C-3
Rear Arm & Suspension Assembly Install:
q
1. Place the left rear Hub (66) between the outer rails of the left
rear suspension Arm (51) (Marked "L"). Be sure that the Ball Stud
(22) is pointed towards the front of the Arm. Position a rear Hub
Spacer (70) between the Hub and the Suspension Arm on each side
of the Hub.
q
2. Insert the outer rear Hinge Pin (71) into the inside hole on the
Suspension Arm, through each of the two Hub Spacers and the
inside hole in the rear Hub. Secure the Hinge Pin with two 1/8" E-
clips (41).
q
3. Repeat Steps 1 and 2 for the right rear Hub (65) assembly.
*Note: Read the VLA section in the back of this manual for
tips on when to use the outer holes on the rear Arms and Hubs..
Step C-4
Rear Hub Assembly Install:
Figure 21
Figure 22
q
1. Attach the plastic rear inner Pivot Block (49) to the rear Pivot
Plate (53) with two 4-40 x 1/2" Flat Head Screws (44) with the Hinge
Pin holes facing rearward. Thread the Flat Head Screws in 3-4 turns
to hold the plastic rear Pivot in place.
q
2. Locate the small Anti-Squat Shims (165) (read the "Anti-Squat"
section in "Tips" for when to use more or less of these). Place one
Anti-Squat Shim between the plastic rear Pivot and the rear Pivot
Plate , making sure the flat edge is towards the outside, and tighten
the two Screws.
IMPORTANT NOTE:
Ensure that the Anti-Squat Shims are com-
pletely under the plastic rear Pivot to provide a rigid mounting sur-
face.
q
3. Attach the rear Pivot Plate to the Chassis (19) using four
4-40 x 3/8" Flat Head Screws (54). Make sure the Pivot Plate is flush
with the Chassis, and the holes in the Pivot Plate and Chassis are
aligned.
q
4. Slide the a rear inner Hinge Pin (52) into the left rear suspension
Arm (51) marked 'L' push the hinge pin into the left side of the plastic
rear Pivot Block.
q
5. Repeat Step 4 for the right rear suspension Arm.
q
6. Slide the aluminum rear Pivot (164) over the rear inner Hinge
Pins with the flat side facing towards the rear of the car. Thread two
4-40 x 3/8" Flat Head Screws through the Pivot Plate into the alumi-
num rear Pivot,
do not tighten them at this time!
IMPORTANT NOTE:
The screws holding the aluminum Rear
Pivot will have to be removed later to allow for the installation of the
Motor Guard, it is important that these Screws are only snug at this
time.
70
54
165
9
51
71
41
22
70
66
44
REAR INNNER
PIVOT SCREWS
53
54
44
164
49
52
51
19
165
52
71
41