![background image](http://html1.mh-extra.com/html/team-losi/bk2/bk2_owners-manual_4004840034.webp)
159
30
BAG G (Continued)
Step G-11
q
1. After Painting, trim the Body (159) along the trim lines (as
shown in Figure 64, emphasized by the dark shading), there is an
indented trim line around the body which can be used as a guide
for trimming.
q
2. Make four 1/4"-diameter holes at the locations marked with
dimples at the front, right side pod, and rear of the left and right
side pods of the Body. These will be the body mounting and
Antenna Tube holes.
q
3. Install the Body onto the rolling Chassis and secure it with
Body Clips (155) through the post on the front Bulkhead (20), and
through the rear Body Mounts (151).
Step G-12
q
1. Trim the rear Wing (160) along the trim lines as shown in
Figure 65.
q
2. Make two 5/32"-diameter holes in the Wing at the locations
marked with dimples.
q
3. Place the rear Wing onto the rear Wing Mounts (56) as
shown in Figure 65. Place a Wing Mount Washer (161) over the
post on each rear Wing Mount.
q
4. Secure the rear Wing and Wing Mount Washers to the rear
Wing Mounts by installing a Body Clip (155) through the hole in
the post on each rear Wing Mount.
Figure 65
Figure 64
155
Rear Wing Install:
Body Trim and Install:
161
155
56
155
161
160
BODY AND WING PAINTING
Prepare the Lexan Body and Wing for painting by washing them thoroughly (inside and out) with warm water and liquid detergent. Dry both the
Body and Wing with a clean, soft cloth. Use the Window Masks (162) supplied to cover the windows
from the inside
. A high-quality masking
tape should be used on the inside of the Body to mask off any stripes, panels, or designs that you wish to paint on the Body or Wing. Use
acrylic lacquer, acrylic enamel, or any other paints recommended for Lexan (polycarbonate). Apply paint to the inside of the Body and the
bottom side of the wing. Remove the tape for the next color and continue. Try to use darker colors first. If you use a dark color after a light color,
apply a coat of white over the lighter color before applying the darker color. This will help prevent the darker color from bleeding through the
lighter color.
STICKERS
Apply the stickers after the mounting of the Body and Wing is complete. Cut the stickers from the Sticker Sheet (163) that you wish to apply
to the Body or Wing. Before removing the protective backing, find the desired location. Remove the backing completely and reattach an edge
of the sticker to the shiny side of the backing material. Using the rest of the backing material as a handle, position the sticker and press firmly
into place to complete its application.
Painting the Body and Wing