![background image](http://html1.mh-extra.com/html/team-losi/bk2/bk2_owners-manual_4004840033.webp)
158
19
157
29
BAG G (Continued)
Step G-9
Step G-10
q
1. Cut a piece of Two Sided Tape (156) to the same size as the
bottom of the receiver
(not included).
Peel one side of the backing
off and stick the Tape to the bottom of the receiver.
q
2. Make sure that the area on the right side of the Chassis (19) is
clean. Wipe this area off with a clean cloth or rag.
*NOTE: Rubbing alcohol can be used to clean any oily residue
that may be present on the Chassis or receiver. Allow the alcohol to
dry before applying the Two Sided Tape.
q
3. Peel the backing off of the Two Sided Tape and install the
receiver to the right side of the Chassis with the antenna wire exiting
the receiver towards the front of the car as shown in Figure 62.
q
4. Run the antenna wire forward to the Antenna Post on the
Chassis. Run the wire into the small hole in the bottom of the Antenna
Mounting Post, and up through the top of the Post.
q
5. Slide the antenna wire through the Antenna Tube (157)
(a
small drop of oil in the tube will make this easier)
so that the wire
comes out the other end of the tube.
*NOTE: If antenna wire is shorter than the Tube,
remove the
Tube
and cut off enough of the Tube so that the wire will extend
about 3/4" past the end of the Tube.
q
6. While pulling the wire through the Antenna Tube, slide the
Antenna Tube down and push it firmly into the Antenna Mounting
Post on the main Chassis.
q
7. Fold the wire down over the Antenna Tube and place the
Antenna Cap (158) over the tube and excess wire.
q
1. Cut a piece of Two Sided Tape (156) to the same size as the
bottom of the speed control (
not included).
Peel one side of the
backing off and stick the Tape to the bottom of the speed control.
q
2. Make sure that the area on the left side of the
Chassis (19) is clean. Wipe this area off with a clean cloth or rag.
*NOTE: Rubbing alcohol can be used to clean any oily residue
that may be present on the chassis or receiver. Allow the alcohol to
dry before applying the two-sided Tape.
q
3. Peel the backing off of the Two Sided Tape and install the
speed control to the left side of the Chassis as shown in Figure 63.
q
4. Run the wire from the speed control through the slot in the left
rail on the Chassis, across the center of the Chassis, and through the
slot in the right rail of the Chassis.
q
5. Plug the speed control wire into the channel 2 slot on the
receiver, then plug the wire from the servo into the channel 1 slot.
Figure 62
Figure 63
Receiver Install:
Speed Control Install: