118
122
120
119
BAG E (Continued)
q
1. Using needle-nose pliers, or small vise grips, grasp the front
Shock Shaft (118) between the grooves and thread a Shock End (120)
onto the Shock Shaft. Thread the Shock End all the way onto the
Shaft until the threads stop.
IMPORTANT NOTE:
Use caution when threading the Shock
Ends onto the Shafts. Avoid gouging or scratching the Shock Shaft,
while gripping Shock Shaft with the pliers, by placing a towel over the
shaft, then gripping the portion of the Shaft covered by the towel.
This will work very well to protect the Shock Shaft.
q
2. Repeat Step 1 for the second front Shaft and two rear Shafts.
q
3. Carefully snap a 1/4" Shock Mount Ball (122) into each of the
Shock Ends on each of the Shafts.
21
q
1. Place a 0.050" Shock Spacer (36) over each of the front Shock
Shafts and move them up against the Shock Cartridges.
q
2. Snap a 1/8" E-clip (41) into the groove closest to the Cartridge
on all four shafts (capturing the Spacers on the front Shock Shafts).
q
3. Slide a #56 (Red) Shock Piston (123) over the end of each Shaft
until it rests against the E-clip. Secure the Pistons to the Shaft with
another 1/8" E-clip placed in the groove now exposed on the top of
the Shaft.
Step E-3
Step E-4
Figure 45
Figure 46
122
Shock End Install:
Shock Piston Assembly:
41
36
123
118
119
41
36
Front
Rear