Taylor-Dunn B0-T48-48 Taylor Truck T48, Руководство по эксплуатации, устранению неисправностей и замене запасных частей, Страница: 78 / 242

Maintenance, Service, and Repair
Transmission
Page 2
CHECK OIL LEVEL
The oil flows freely between the main gear case (3rd
member) and the primary reduction gear case. It is only
necessary to check the oil level of the 3rd member.
Park the vehicle on a level surface.
6. Place an oil drain pan underneath the 3rd member.
7. Remove the fill/level plug.
8. The oil level should be very close to the bottom of
the level plug opening.
a. If the oil level is below the bottom of the opening,
add oil as required until level with the bottom of
the opening. Refer to the
Lube Chart section
for information regarding type of oil.
b. If oil comes out of the opening, allow to drain
until level with the bottom of the opening.
9. Replace the fill/level plug.
10. Reconnect the main positive and negative cables
at the batteries.
11. Remove the blocks from the wheels.
12. Release the park brake and test drive the vehicle.
CHANGE OIL
6. Raise the rear of the vehicle and support with jack
stands.
7. Place a four quart drain pan under the drive
assembly.
8. Remove the drain plugs from the differential case
and gear case.
9. Once the oil has drained, replace the drain plugs
and lower the vehicle to the ground.
10. Remove the fill/level plug and fill the differential
up to the bottom of the level plug opening. Refer
to the
Lube Chart
section for information
regarding type of oil.
11. Replace the fill plug.
12. Reconnect the main positive and negative cables
at the batteries.
13. Remove the blocks from the wheels.
14. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.
1. Make sure the key-switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.